UV lamp voltage 110V 220V 380V

Thu, 25 Jun 2026 09:16:01 +0800

From fabric coating to the final label pass, UV curing has to hold tight tolerances on a line that never slows down. If lamp power and supply voltage don’t line up, you’re staring down undercured ink, adhesion issues, and scrap. Our mercury vapor UV lamps are built to handle 110V, 220V, and 380V inputs. The core design stays the same, so you can drop it into different plant electrical setups without re-engineering the curing station. What actually matters is energy delivery, not voltage by itself. We lock in stable spectral output centered at 365nm, matched to the photoinitiators in screen and flexo inks. Peak irradiance is calibrated to hit the required mJ/cm² right at the substrate surface. Reflector geometry and dichroic coatings squeeze out every last photon, and ozone-free operation keeps ozone extraction loads predictable downstream. Lamp life is targeted at 1,500–2,500 hours under industrial duty cycles, with output held within a narrow window so curing doesn’t drift. In textile work, the point is simple: the lamp fits the line, not the other way around. Because the spectral profile stays consistent across voltage variants, curing profiles stay repeatable when you move a machine between sites or rebalance a line. That translates to fewer speed cuts, less scrap, and adhesion that stays stable on coated fabrics, printed graphics, and tags. Energy draw tracks to the irradiance you need, and the voltage flexibility sidesteps costly rewiring or transformer changes. On install, match the lamp to the fixture’s arc length and reflector geometry. Before commissioning, confirm your power supply’s nominal voltage and its tolerance band. With thick coatings, verify peak irradiance and dwell time so you get full cross-linking through the layer. Run the lamp outside its specified voltage window, and you shorten life and throw off spectral output.

110V on UV Curing Lab

UV lamp voltage 110V 220V 380V